TA 544 User Manual/61200704L1-1A
Page 47 of 68
© 2001, ADTRAN, Inc.
TA 544 User Manual
The following settings are used for FRF5.
L
AN
FR M
AINT
P
ROTOCOL
Frame Relay maintenance or signaling protocol
between local V.35 port and the attached DTE
port, support ANSI Annex A, CCITT Q933 An-
nex D, CISCO LMI or Static (no signaling).
L
AN
FR P
OLL
T
IMEOUT
T392 (5-30)
T392 for signaling protocol, typical value 15. No
meaning if Maint Protocol is Static.
FRN P
ORT
C
ONFIG
Logical Frame Relay ports over ATM. Up to 4
ports are supported with each port supporting up
to 4 DLCI mappings. Go to
N
UM
field. Typing "i"
or "I" will insert another entry, and typing "d" or
"D" will delete one entry.
N
AME
To identify your port.
ATM VPI
Specifies the virtual path over which this
logical port is running.
ATM VCI
Specifies the virtual circuit over which this
logical port is running.
D
E
M
AP
Frame Relay to ATM DE mapping; default
value (
F
RN
O
NLY
,
ATM 0
) suggested.
CLPI M
AP
ATM to Frame Relay CLPI map; default
value (
F
RN
O
NLY
) suggested.
D/C
Set D/C field in the header to 0 or 1.
H
EADER
Header format; only 2 bytes supported now.
M
AINT
P
ROTOCOL
Maintenance or signaling protocol over this
logical Frame Relay port. Support Annex A,
Annex D, CISCO LMI or Static.
M
UX
M
ODE
Many DLCIs or one DLCI mapping over this
port.
DLCI M
AP
Actual DLCI mappings.
L
AN
DLCI
The DLCI configured over local V.35
Frame Relay port.
N
ET
DLCI
The DLCI configured over the WAN
side logical Frame Relay port.
A
CTIVE
Always active, not configurable.
