SDG-ST1 Fiber Tray QSG
Installing the Fiber Tray
5. Align the narrower end of the fiber tray with the narrower end of the bottom of the SDG unit. Route the fiber through the center hole in the
fiber tray and connect the cable to the SDG unit as show in
.
Figure 2. Connect the Fiber to the SDG Unit
6. Locate the two attachment clips on the fiber tray and align them with the two holes on the bottom of the SDG unit as shown in
Carefully snap the fiber tray into place on the bottom of the SDG unit, ensuring not to crimp the fiber cable between the bracket and the
SDG. Reinstall the two Phillips screws through the fiber tray.
Figure 3. Align the Fiber Tray to the SDG Unit and Snap Into Place
7. Once the fiber tray is attached to the bottom of the SDG, the installation is complete. Rotate the SDG back to the upright position.
NOTE
g
SDG device wiring, powering, and operating instructions are available in the Quick Start Guide associated with the SDG product. All quick
start guides are available online in the
Service Delivery Gateways (SDGs)
Additional product information, quick start guides, and
configuration guides provide additional information for
Adtran’s SDG products are available online at
For ADTRAN training inquiries, visit:
Access additional safety information and product documentation using the QR
code or website link.
https://supportcommunity.adtran.com
Warranty:
ADTRAN will replace or repair this product within the warranty period if it does not
meet its published specifications or fails while in service. Warranty information can
.
Trademarks:
Brand names and product names included in this document are trademarks,
registered trademarks, or trade names of their respective holders.
Copyright © 2023 ADTRAN, Inc. All Rights Reserved.
C A U T I O N !
SUBJECT TO ELECTROSTATIC DAMAGE
OR DECREASE IN RELIABILITY
HANDLING PRECAUTIONS REQUIRED
*617600195F1-13A*
ADTRAN CUSTOMER CARE:
From within the U.S. 1.888.423.8726
From outside the U.S. +1 256.963.8716
PRICING AND AVAILABILITY 1.800.827.0807
