Verifying Your Configuration Using Show Commands
NetVanta 950 IAD Configuration Guide
36
© 2004 ADTRAN, Inc.
61200788L1-29.1B
3. VERIFYING YOUR CONFIGURATION USING SHOW COMMANDS
Use the following AOS
show
commands to display information regarding your configuration. While in
configuration mode, enter the
do
command followed by the
show
commands.
For example: (config-t1 0/1)#
do show interface t1 0/1
Command
Description
Sample Output
show interface t1 0/1
Shows current settings,
status for T1 interface 0/1
t1 0/1 is UP
T1 coding is B8ZS, framing is ESF
FDL type is ANSI
Line build-out is 0dB
No remote loopbacks, No network loopbacks
Acceptance of remote loopback requests enabled
Last clearing of counters never
loss of frame: 0
loss of signal: 0
AIS alarm: 0
Remote alarm: 0
DS0 Status:
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4
N N N N N N N N N N N N N N N N N N N N N N N N
Status Legend: '-' = DS0 is unallocated
'N' = DS0 is dedicated (nailed)
Signaling Bit Status:
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4
RxA:
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
RxB:
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
TxA:
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
TxB:
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4
Line Status: -- No Alarms --
Current Performance Statistics:
10 Errored Seconds, 0 Bursty Errored Seconds
0 Severely Errored Seconds, 10 Severely Errored Frame Seconds
10 Unavailable Seconds, 0 Path Code Violations
0 Line Code Violations, 1 Controlled Slip Seconds
0 Line Errored Seconds, 0 Degraded Minutes
TDM group 1, connection is RBS
Cross-connected to analog interfaces
TDM group 2, connection is RBS
Cross-connected to analog interfaces
