ADTRAN NetVanta 1234, Hardware Installation Manual

Page: 22 / 28

Unit Installation NetVanta 1230 Series Hardware Installation Guide
22 Copyright © 2014 ADTRAN, Inc. 61702594G1-34D
4. UNIT INSTALLATION
The instructions and guidelines provided in this section cover hardware installation topics, such as mounting
options, supplying power to the unit, and installing option cards. These instructions are presented as follows:
• Tools Required on page 22
• Mounting Options on page 23
• Supplying Power to the Unit on page 25
For information on configuring a specific application, refer to the configuration guides or the AOS Command
Reference Guide provided on the ADTRAN Support Community at https:supportforums.adtran.com .
Tools Required
The customer-provided tools required for the hardware installation of the NetVanta are:
• Ethernet cables
• Phillips-head screwdriver
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
• The NetVanta 1230 Series is intended to be to be installed, maintained, and serviced by
qualified service personnel only and should be installed in a restricted access location
as described in UL/IEC 60950-1.
• Ethernet cables are intended for intrabuilding use only. Connecting an ADTRAN unit
directly to Ethernet cables that run outside the building in which the unit is housed will
void the user's warranty and could create a fire or shock hazard. To connect an
ADTRAN unit to Ethernet cables that run outside the building, ADTRAN's Ethernet Port
Protection Device (EPPD) (P/N 1700502G1) must be connected between the unit and
the outside plant cable. Use of any Ethernet protector other than ADTRAN's for this
purpose will void the user's warranty.
• PoE cables are intended for intrabuilding use only. Connecting an ADTRAN PoE unit
directly to PoE cables that run outside the building in which the unit is housed will void
the user's warranty and could create a fire or shock hazard.
• For outdoor PoE applications, ensure any PoE injector used is approved and rated for
outdoor/exposed wiring applications. Use of a PoE injector that is not rated for
outdoor/exposed wiring applications will void the user's warranty and could create a
fire or shock hazard.
TTo access the CLI of the NetVanta, you will also need a PC with terminal emulation
software and a console port cable. Instructions on how to access the CLI are available in
the quick start guide shipped with your unit or online at
ADTRAN’s Support Forum .