ADTRAN ISU 128, User Manual

Page: 86 / 152

61202.029L2-1 ISU 128 User Manual 71
Chapter 10
Remote Configuration
Remote Configuration
Remote Configuration allows configuration and testing of a remote unit by
calling the remote unit from a local unit. The remote unit can be configured
using AT commands, the Front Panel, or the VT 100 terminal interface.
There are six items that cannot be set through remote configuration. The items
are Dial Line Mode, SPID(s), LDN(s), Switch Type, Quick Setup, and Factory
Default.
Configuring with AT Commands
A remote unit can be configured by issuing an ATD command with the phone
number of the remote unit plus a dial string modifier. The configuration com-
mand syntax is:
ATD nnnnnnn#6#yyyyyy
Where nnnnnnn is the remote number to call, and yyyyyy is a password of up
to six digits.
After the connection is established, AT commands issued to the local unit are
sent to the remote unit and executed. The remote unit sends response back to
the local unit which then sends the response out of the DTE interface connec-
tor. See the appendices AT Commands and S-Registers of the ISU 128 manual
for a complete list of commands.