ADTRAN Express 3000 SP, User Manual

Page: 85 / 118

Appendix A. AT Commands and S-Registers
61203153L3-20 Express 3000 SP User Manual A-11
S25
DTR Detect Time Determines time, in hundredths of a second, that must
elapse before the Express 3000 SP recognizes a change in
DTR.
Range = 0 to 255
S27
PPP Mode Value determines whether or not PPP will be a single-link
or multilink connection.
0=Single-link operation (default)
1=Multilink operation
2=Use compression
S30
DTE CTS Controls the operation of the DTE connector CTS line.
0=Follows RTS
1=Force CTS
S31
DTE RTS Controls operation of the RTS line.
0=1 ms delay
1=18 ms delay
S32
DTE DSR Controls the operation of the Data Set Ready signal on the
DTE connectors.
0=Force DSR on always
1=DSR off OOS + Test
2=DSR off Link Down
S33
DTE CD Controls the operation of the Carrier Detect line on the
DTE connectors.
0=Force CD on always
1=CD is active during a call (Normal Operation)
2=Off with LOCD
3=Off link down
S34
DTE DTR Determines how the Express 3000 SP responds to changes
in DTR. This is a bit-mapped register.
0=Ignore DTR
1=Force AT command mode when DTR is off
2=Dump incoming call when DTR is off
4=Hang up incoming call when DTR is off
8=Hang up outgoing call when DTR is off
16=Answer incoming call when DTR is on
28=Idle when off
32=Dial SN0 when DTR is on
64=Dial SN0 when DTR transitions from off to on
S36
Inactivity Timer 0=Off
1-255=Number of idle minutes before disconnect
S-Registers List
(Continued)
Command
Function Features