ADTRAN DSU IV ESP, User Manual

Page: 65 / 194

Chapter 6. Configuring Network Options
61204011L1-1 DSU IV ESP User Manual 6-3
Table 6-1. Network Options AT Commands
Loop Rate
The L
OOP
R
ATE
option sets the loop operating speed. The unit
should be set to the rate required by the DDS Service. The DSU IV
ESP also supports subrate DTE data over a 56 or 64 kbps loop. The
loop rate must be set independently of the DTE rate. Eight loop rate
selections are available. See Figure 6-1.
The default factory setting is A
UTO
. The various loop rates and
format selections are listed in Table 6-1 on page 6-3 with the
Front Panel AT Command
Loop Rate
AUTO %B0
2.4K %B1
4.8K %B2
9.6K %B3
19.2K %B4
38.4K %B5
56K %B6
64K %B7
Network Address
XX (decimal) _N=xx
Remote Configuration
1 = DISABLED &P4
2 = ENABLED &P5
Network Type
1 = DEDICATED none
2 = AT&T/MCI SW56 none
3 = US SPRINT SW56 none
Clock Source
1 = Master _X0
2 = FROM NETWORK _X1