2
61700948F1-13E
Figure 2. BSAP Mounting Bracket Kits
2. For the BSAP 2035 only: Install the antennas (sold
separately) onto the appropriate antenna ports. The antenna
ports are labeled
2.4G
and
5G.
3. Once the mounting bracket is attached to the BSAP, align
the mounting bracket at a slight angle to the T-rail. Slide the
long bracket tabs onto the T-rail and rotate slightly until the
flexible bracket tabs snap into place.
Figure 3. BSAP Dropped Ceiling Mount
4. Optionally protect your BSAP with a Kensington cable lock
(not provided) inserted in the security slot.
Supplying Power to the BSAP
The BSAP does not have a power switch. It is powered when
connected to a network device that supplies PoE based on the
IEEE 802.3af or 802.3at standard, or optionally by the following:
■
External 802.3af PoE injector (P/N 1700926F1)
■
External 802.3at PoE injector (P/N 1700923F1)
■
External 2 amp DC power adapter (P/N 1700929F1)
connected to an AC power source
Screws
Recessed Ceiling
Mounting Bracket
Flush Ceiling
Mounting Bracket
BSAP 2035 with
Antennas Mounted
T-rail
BSAP 2035 with
Antennas Mounted
Recessed Ceiling Mounting Bracket
Mounted on T-rail
2. Using a 0.25-inch (0.65 cm) drill bit, drill two holes in the
ceiling or wall 2.75 inch (4.45 cm) apart, and tap the anchors
into the holes.
3. Drive the provided mounting screws into the plastic anchors
leaving enough of the screws exposed to ensure that the
screws can be inserted into the keyed slots in the bottom of
the unit.
4. Insert the screws into the keyed slots on the bottom of the
BSAP and slide the BSAP forward (or backward) on the
screws to securely mount it in place.
5. Optionally, protect your BSAP with a Kensington cable lock
(not provided) in the security slot.
Figure 1. BSAP Hard Ceiling Mount
Mounting the BSAP to a Dropped Ceiling
Position the BSAP for maximum throughput and range between
other BSAPs and wireless client devices.The BSAP 2030/2035
ships with plastic flush and recessed ceiling mounting brackets (T-
rail kits) to mount the BSAP on the ceiling tile separators of
standard and recessed dropped ceilings. Complete these instruc-
tions and refer to
to mount the BSAP to a dropped
ceiling:
1. Attach either the flush or recessed ceiling mounting bracket
to the back of the BSAP using the included mounting
screws.
Keyed Slots
Plastic Anchors
Mounting Screws
BSAP 2035 with
Antennas Mounted
Wall or Ceiling
