4
Copyright © 2013 ADTRAN, Inc. All Rights Reserved.
Quick Start Guide, 61700952F1-13C, October 2013
5
To mount the BSAP 1940 to a horizontal pole:
1. Place the lock washers, then the flat washers on the four hex cap screws, and drive the screws
through the plane bracket into the back of the case as shown in Figure 4.
2. Drive the four round head screws to attach the pole mount base to the plane bracket in a horizontal
position (Figure 8).
3. Thread the open end of the hose strap through the two tabs on the pole mount base (Figure 9).
4. Install the antennas (sold separately) onto the appropriate antenna ports. The antenna ports are
labeled
2.4GHz
and
5GHz
.
5. Wrap the hose strap around the horizontal mounting pole and insert the end into the strap lock.
Tighten the lock of the hose strap to secure the unit to the pole (Figure 11).
8
9
Round Head
Screw
Pole Mount
Base in
Horizontal Position
Hose Strap
Insertion
10
11
Vertical
Pole
Mounting
Horizontal Pole
Mounting
S
UPPLYING
P
OWER TO THE
BSAP
The BSAP 1940 does not have a power switch. It is powered when connected to a network device that
supplies PoE based on the IEEE 802.3at standard or an external PoE injector. To power the BSAP
1940, follow these instructions:
Connect the PoE Cable to the BSAP
1. Disassemble the watertight fitting by unscrewing the cinch nut and pushing the rubber gasket out
of the strain-relief fitting.
2. Thread the cinch nut onto the customer-provided RJ-45 CAT 5e or CAT 6 cable.
3. Spread the gasket open and wrap it around the cable near the RJ-45 connector.
4. Insert the RJ-45 connector through the strain-relief fitting, and press the gasket back into its
original position.
5. Insert the connector into the RJ-45 receptacle on the bottom of the BSAP.
6. Gently push the strain-relief fitting along the cable until it engages with the black threads, and
screw the it onto the BSAP until it is well seated against the unit.
7. Screw the cinch nut onto the strain-relief fitting until it is well seated against the gasket forming a
watertight seal.
The watertight fitting must be used when connecting the PoE cable to the
BSAP 1940.
Without the watertight fitting, connecting an ADTRAN PoE unit directly to
PoE cables that run outside the building in which the unit is housed will
void the user's warranty and could create a fire or shock hazard.
5GHz
5GHz
Cinch Nut
Gasket
Strain-relief
Fitting
Antenna
Connectors
RJ-45 Receptacle
and Connector
