ADTRAN 424RG Quick Start Download Page 1

Page: 1 / 4

Quick Start

ESCRIPTION

The 424RG/434RG Optical Network Terminal (ONT) Fiber Tray
and Wall Mount Bracket (ONT Fiber Tray and Bracket) is used to
mount either of the following ONTs to a wall:

■

ADTRAN 424RG 2 POTS/4 GigE Dual Band WiFi ONT
(P/N 1287781F1)

■

ADTRAN 434RG 2 POTS/4 GigE RF MoCA Dual Band WiFi
ONT (P/N 1287782F1)

Required Tools

The following tools are required when installing the ONT Fiber
Tray and Bracket.

■

Power drill (optional)

■

Carpenter’s level (optional)

■

Phillips-head Screwdriver

■

Hammer

Installation Steps

To install the ONT Fiber Tray and Bracket, complete the following
steps:

1. Select Location and Mount Bracket.
2. Attach Incoming Fiber Cable to Bracket.
3. Remove Base (if required) from ONT.
4. Remove Logo Panel from ONT.
5. Connect Incoming Fiber Cable to ONT.
6. Attach ONT to ONT Fiber Tray and Bracket.

Step 1: Select Location and Mount Bracket

Select a location to mount the ONT Fiber Tray and Bracket near
the fiber entrance. Use the supplied hardware to mount the
bracket to the wall as follows:
Supplied hardware is intended for drywall mounting only. For
mounting on surfaces other than drywall, obtain the appropriate
mounting hardware and follow the provided instructions.

1. Refer to

Figure 1

and mark hole locations using the ONT

Fiber Tray and Bracket as a template. Use a carpenter’s
level to ensure the bracket is level.

2. Start anchor into the wall by using a hammer to lightly tap

the anchor in until the threads are close to the wall.

NOTE

Pre-drill holes using a 1/4” drill bit if difficulty is encountered.

3. Insert either a No. 2 or No. 3 Phillips driver bit into the recess

of the anchor head.

4. Using gentle forward pressure, rotate the wall anchor

clockwise until the collar is flush with the wall.