ADTRAN 1202052L1, User Manual

Page: 31 / 136

Chapter 2. Installation
61202052L1-1 TSU 100 User Manual
2-7
Initialization
Set User Passcode
The TSU 100 is designed to operate with or without the use of a
passcode. The default condition is without a passcode.
If the unit is to be remotely accessed using T-WATCH Pro, you
must enter a passcode. When managing a number of units, the
passcode can be the same for all the units.
The passcode should be a number easily remembered. Once
entered, the passcode is required to access any operation other
than viewing. See Set Passcode on page 6-3 for details.
Set Unit Identification
The Unit ID sets the unit to respond to remote control (con-
trolled by a device other than the front panel or terminal). If no
Unit ID is recorded, it is not possible to operate from any
remote control device, including the local PC for T-WATCH Pro
or SNMP. See Unit ID Menu on page 6-5 for details.
Set Chain Port
The TSU 100 can be configured from the chain-in port when
either T-WATCH Pro, SNMP, or the terminal interface is being
used. If the chain-in port is to be used, the chain-in port baud
rate must also be selected.
Chain-In (PC)
The unit can be controlled from an external PC connected
directly or via modem to the Chain-In port. When using Chain-
In, the selection of the chain-in port baud rate from 9600 (fac-
tory default), 1200, 2400, 19200, or 38400 must be made using
the Unit Configuration menu. See Unit Menu on page 5-11 for
details.
Unless locked out externally, the front panel can also control
the unit.