ADTRAN 1202052L1, User Manual, Page: 83 / 136

Chapter 6. Utility Menu
61202052L1-1 TSU 100 User Manual
6-5
Unit ID Menu
This menu is used to access the current Unit ID setting. View-
ing is available in limited access mode. Editing or changing the
Unit ID requires the use of a password as in editing mode. Unit
ID numbers must be between
2 and 999 . If an out-of-range
number is entered, the unit assumes the upper limit number of
999 .
To Set the Unit Identification
In the Unit ID Menu (item 4) under the UTIL Menu , enter any
value between 2 and 999 . The number 1 is reserved for the PC.
Press
Enter
to record the Unit ID number and establish its
availability for operation by remote control. The unit proceeds
to the
Set Control Port prompt.
No Unit ID Desired
Without entering any numbers at the Unit ID prompt, press
Enter
. Pressing
Enter
with no Unit ID recorded establishes the
unit as not able to be operated by remote control.
Port Utility
This menu provides access to the display of the current soft-
ware information for each port installed in the unit. This infor-
mation is required when requesting assistance from ADTRAN
customer service or when updates are needed.
Software Revision (Software Rev)
This menu provides access to the display of the current soft-
ware revision level loaded into the base unit controller. This
information is required when requesting assistance from ADT-
RAN Customer Service or when updates are needed.
Press
Cancel
to exit.