ADTRAN 1200275L1, User Manual

Page: 40 / 198

Chapter 2. Installation
2-2 TSU IQ+ User Manual 61200275L1-1
The following items are included in ADTRAN shipments of DBU
cards:
• DBU card
• An 8-position modular to 8-position modular cable for the
4-wire SW56, ISDN, or PRI DBU options or an 8-position
modular to 4-position modular cable for the V.34 DBU option
Customer Provides
The customer must provide a male V.35 interface cable.
For SNMP management not accessed through the
V.35
or
Network
port, the customer must provide access to the TSU IQ+ either
through a SLIP, Async PPP (requires a male 25-pin D-type
connector), or a through the
10BaseT Ethernet
port (requires that an
ADTRAN Ethernet card be installed in the TSU IQ+). See Pinouts
on page A-1 for the pin assignments of the
C
ONTROL
port (for SLIP
and Async PPP) and the E
THERNET
port.
Power Up
The TSU IQ+ is provided with a captive 8-foot power cord,
terminated by a three-prong plug which connects to a grounded
115 VAC power receptacle.
REAR PANEL
The rear panel contains a DTE connector which provides primary
channel
V.35
. An 8-pin Network jack, Test Jacks, a DSX-1 port, a
Control port, a captive power cord, and a power switch are also
located on the rear panel. Pin assignments for these connectors are
Power to the TSU must be provided from a grounded 115 VAC, 60 Hz re-
ceptacle.