ADTRAN 1200270L1, Manual

Page: 66 / 132

Chapter 6. Configuring DTE Options
6-14 DSU III ARdc User Manual 61200270L1-20
SR Options
The SR O
PTIONS
menu is used to select the operating mode for the data set
ready (SR) lead. Press
Shift + A
to activate the SR O
PTIONS
sub-menu. The
factory default setting is O
FF
T
EST
O
NLY
(shown in Figure 6-11 ).
Figure 6-11. Setting SR Options
For I
DLE
W
HEN
O
FF
option: In SW56 mode, TR off causes the
DSU to go On Hook (Idle). The unit also does not dial out if TR
is off. In dedicated mode, the DSU goes into DTE command mode
when TR goes off. When TR goes on, if the DSU does not receive
a command in the number of seconds set in S40, the DSU goes
into data mode.
1=NETWORK OPT.
1=DTE RATE
2=CONNECTOR TYPE
3=DATA FORMAT
2=DTE OPTIONS 4=DTE CMD OPTION
5=TRANSMIT CLOCK
1=LOCAL 6=CS OPTIONS
7=ANTI-STREAM
3=CONFIG 8=CD OPTIONS 1=FORCED ON
2=REMOTE ENTER ADDRESS 9=TR OPTIONS 2=OFF OOS ONLY
A=SR OPTIONS 3=OFF LOCD ONLY
4=OFF TEST ONLY
5=OFF TEST +OOS
3=TEST OPTIONS 6=OFF TEST +LOCD
4=DIAL OPTIONS
5=MANUAL