ADTRAN 1200182L1, User Manual

Page: 26 / 50

Chapter 3. Operation Async-232 Module Submenus
Configuration
3-10 Async-232 Module User Manual 61200182L1-1
Call Rejected - Busy
The Dial Plan configuration could not find a resource within ATLAS that
would accept the call.
No Such Number
The Dial Plan configuration could not route the dialed number.
Call Error
The Dial Plan configuration returned an error for the dialed call attempt.
Hangup
Read security: 5
Allows forced disconnection of an active call on the port. A dialog box asks you to
confirm your decision to hang up (see Figure 3-7).
Figure 3-7. Hangup Confirmation Dialog Box
Configuration
Read security: 5
This submenu configures the Async-232 Module ports (see Figure 3-8). Once
selected, configuration options immediately take effect. All fields are read and
write, although the availability of some fields depends on options chosen in other
fields. The Async-232 Module port data format assumes 8 data bits, no parity, and
1 stop bit (8N1).
Figure 3-8. Configuration Submenu Panel
Some fields may be modified using either the Terminal menu interface or AT com-
mands. Terminal menu values always represent the stored NVRAM profile for
the port, and the current profile represents any changes made to the stored profile
via AT commands.
The &V AT command displays the current and stored profile for AT parameters.
When a field is modified using AT commands, the value set with the AT com-
mand overrides the menu setting for the session. This value is not displayed in
the Terminal menu until the session profile is written to non-volatile memory