ADTRAN 1200063L1, Manual

Page: 93 / 137

Chapter 9. Configuring Dial Options
61200063L1-20 DSU III TDM User Manual 9-3
Phone Number
The DSU III TDM has storage available for ten numbers of 36 digits each.
To edit a phone number, reenter the entire number. This process over-
writes the previously stored number. Figure 9-2 shows the menu path
used to access the
P
HONE
N
UMBER
option.
Enter only the phone number; do not add dashes, parentheses or commas.
Figure 9-2. Editing a Stored Phone Number
ISDN Dial Backup
If a clear channel 64 kbps circuit is required to back up the DDS circuit,
placing #4 at the end of the smart dial string (phone number entered into
Stored Number 1-8) causes the ISDN DBU mode to establish the backup
connection at 64 kbps instead of 56 kbps. For example: 2059718000#4.
Setting the Service Profile Identifier (SPID)
For ISDN dial backup, the service profile identifier (SPID) must be entered
in Stored Number 9. The SPID is a sequence of digits used to identify
ISDN terminal equipment to the ISDN switch when more than one ISDN
set has been attached to the same central office line. The SPID is assigned
by the telco when the ISDN line is installed and normally resembles the
phone number.
Generally, the 5ESS custom switch is configured for a point-to-point net-
work and a SPID is not required. SPID is required for 5ESS or Northern
Telecom switches with ISDN National 1 interface.
1=NETWORK TYPE
2=DTE OPTIONS
1=LOCAL 3=TEST OPTIONS
STORED NUMBER TO
3=CONFIG 1=PHONE NUMBER EDIT: (1-10) NNNNNNN
2=REMOTE 4=DIAL OPTIONS EDIT SPID
2=DBU OPTIONS STORED NUMBER 9 NUMBER
5=MANUAL
EDIT LOC
STORED NUMBER 10 DIRECTORY NUM