background image

Debug Output

Activate debug dialer and debug ppp negotiation, then initiate a ping to the peer. The router should attempt
to dial. Once the ISDN connection is established PPP negotiation should begin. The following debug output
shows a successful call.

Router#show debug

Dial on demand:  Dial on demand events debugging is on

PPP:  

  PPP authentication debugging is on  

  PPP protocol negotiation debugging is on

Router#ping 192.168.180.22

  Type escape sequence to abort.

   Sending 5, 100−byte ICMP Echos to 192.168.180.22, timeout is 2 seconds:

 Serial1: Dialing cause ip (s=192.168.180.2,d=192.168.180.22)

!−−− Dialing cause is ping to 192.168.180.22.

   Serial1: Attempting to dial 5551111&5551112

!−−− Call is dialed out using Serial1 

   !−−−(which is connected to the ADTRAN).

   !−−− Remember that ADTRAN handles the ISDN L1−L3, so ISDN messages

   !−−− will not be visible on the router.

   Se1 UNKNOWN(0x00FF): LCP not open, discarding packet.

   Se1 UNKNOWN(0x00FF): LCP not open, discarding packet

   Se1 LCP: I CONFREQ [Closed] id 49 len 15

!−−− PPP Negotiation begins.

   Se1 LCP: AuthProto CHAP (0x0305C22305)

   Se1 LCP: MagicNumber 0x65FF6351 (0x050665FF6351)

   Se1 LCP: Lower layer not up, discarding packet

   %LINK−3−UPDOWN: Interface Serial1, changed state to up.

   Se1 PPP: Treating connection as a callout

   Se1 PPP: Phase is ESTABLISHING, Active Open

   Se1 LCP: O CONFREQ [Closed] id 47 len 15

   Se1 LCP: AuthProto CHAP (0x0305C22305)

   Se1 LCP: MagicNumber 0x048333B0 (0x0506048333B0)

   Se1 LCP: I CONFACK [REQsent] id 48 len 15

   Se1 LCP: AuthProto CHAP (0x0305C22305)

   Se1 LCP: MagicNumber 0x048333B0 (0x0506048333B0)

   Se1 LCP: I CONFREQ [ACKrcvd] id 50 len 15

   Se1 LCP: AuthProto CHAP (0x0305C22305)

   Se1 LCP: MagicNumber 0x65FF6351 (0x050665FF6351)

   Se1 LCP: O CONFACK [ACKrcvd] id 50 len 15

   Se1 LCP: AuthProto CHAP (0x0305C22305)

   Se1 LCP: MagicNumber 0x65FF6351 (0x050665FF6351)

   Se1 LCP: State is Open

   Se1 PPP: Phase is AUTHENTICATING, by both

   Se1 CHAP: O CHALLENGE id 11 len 42 from "Router"

   Se1 CH.AP: I CHALLENGE id 11 len 30 from "peer"

   Se1 CHAP: O RESPONSE id 11 len 42 from "Router"

   Se1 CHAP: I SUCCESS id 11 len 4

   Se1 CHAP: I RESPONSE id 11 len 30 from "peer"

   Se1 CHAP: O SUCCESS id 11 len 4 

!−−− Authentication is successful.

   Se1 PPP: Phase is UP

   Se1 IPCP: O CONFREQ [Closed] id 16 len 10

   Se1 IPCP: Address 192.168.180.2 (0x0306CF12B402)

Summary of Contents for 1200.051










Reviews: