ADT Model 927 Water Recycling System
P/N 90927-SPPM-000-00
iii
3.
PREVENTING MAINTENANCE PROCEDURE
Caution:
Cleaning and replacing the water filters may cause water to spill on the
system and on the floor.
Place cloths or other absorbent material under the
cleaned/replaced filter to absorb the water.
Note:
Cleaning and replacing the filters requires putting the system in standby
mode or powering down.
3.1
Water tanks cleaning
After working with the System for a long period, dicing debris
accumulates in the sediment water tank.
To empty the water tank:
Power down the System.
Remove the rear lower cover.
Put a bucket or a vacuum cleaner near the sediment water tank cork,
and open the cork.
Do the same for the supply water tank.
Use a piece of cleaning cloth or cleaning paper towel to remove all
sediments of sediment water tank. Clean the inside of the tank. In
addition clean the water level sensors.
Do the same for supply water tank.
Figure 3-1. Clean water tanks