ADT Model 927 Water Recycling System
P/N 90927-SPPM-000-00
xi
Figure 3-14. Standby screen
Note:
The front lower door has a sensor. When the door is open, the System
goes into standby mode.
3.6.1
Powering OFF
Powering OFF is performed when the system is not in use, or before
performing maintenance and service procedures.
Note:
This should be done only after stopping the dicer cutting process.
To power down the system:
Press the Run/Standby button to go into Standby mode.
Toggle the system Main Circuit Breaker to its OFF position.
