ADT 927, Maintenance Manual

Page: 18 / 19

ADT Model 927 Water Recycling System
P/N 90927-SPPM-000-00
xii
4. PREPARING THE SYSTEM
The 927 Water Recycling System is used for recycling the dicing saw
cutting water. Therefore, preparing the System requires connecting the
927 System to a dicing saw.
Preparing and setting the system includes the following actions:
 Inspecting the valves orientation (section 4.1)
 Filling the water tank with fresh water (section 4.2)

Bleeding air from the pumps (section 4.3)

Checking to ensure there are no water leaks (section 4.4)
 Placing the System (section Error! Reference source not found.)
4.1 Inspecting Valves Orientation
Before operating the System, verify the manual (orange) valves are in the
required orientation.
Remove the upper and lower front covers on both sides of the System.
Verify the valves are oriented as follows:

Pump 1 (P1):

In: open

Out: open

Pump 2 (P2):

In: open
 Out: open

Pump 3 (P3):

In: open
 Out: open

Filter 1 (F1) (pre-filter):
 In: open
 Out: open
 Manual drain: closed

Filter 2 (F2) (slurry bag-filter):
 In: open
 To sink tank: open

To external drain: closed