iCamera-1000-ADT Indoor Low-Light Camera Installation Guide
Installation
This section provides details of installing and configuring the iCamera-1000-
ADT Indoor Low-Light camera.
Configuring and Installing the iCamera-1000-ADT
The following instructions provide details of configuring and installing the
iCamera-1000-ADT Indoor Low-Light Camera to your ADT Pulse network.
Initial setup is done only one time to configure the
iCamera
’s wireless settings to
the ADT Pulse Gateway.
Figure 3: Initial Setup
1.
Connect the LAN Cable to the iCamera
a.
Connect the LAN Cable to the LAN Port located on the back of the
iCamera
.
b.
Place the other end of the LAN Cable into the LAN Port of the Y-Cable.
2.
Connecting the Y-Cable to the Gateway
c.
Connect the Y-Cable (with Ethernet) into the Device LAN port of the
gateway.
3.
Connecting the Power Source
d.
Connect the Y-Cable power adapter into the power source. Once
connected, plug the power source into an electrical outlet.
IMPORTANT
DO NOT USE ANY POWER ADAPTER OTHER THAN THE
ONE SPECIFIED. DOING SO MAY DAMAGE THE
DEVICE.
NOTE:
During start up, the Power LED displays for approximately 10 to
15 seconds. When installation is complete, the Power LED and
the Network LED remain ON.
ADT Pulse
®
Interactive Solutions
5
