MES9000 series
−
Instruction manual v1.1
18
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
4.3 Attaching using a tube adapter
1.
Deburr
the end of your support tube (diameter 48.3 mm).
2. Stick the
drilling template
around the end of the support tube so that the holes to be drilled are
located on the rear side of the tube. Next, drill two
4-mm holes
:
3. Twist off the sealing sleeve:
4. Apply a suitable
lubricant
to the seal and the tube end to make it easier to slide on the sealing
sleeve (e.g. soap or fitting grease, depending on the application type).
5. Slide the sealing sleeve onto the tube and check again that the
seal
is seated correctly. Then, add
the
spacer ring
.
