3. Remove clip and float.
4. Remove stem.
5. Reassemble in reverse order making sure that float is installed right side up.
7.4.10 POWER or CYLE START SWITCH REPAIR
(See Figure 7.4.10)
1. Disconnect wires from all four terminals.
2. Remove lens (1) from front of switch.
3. Remove collar (2).
4. Remove small gasket (3).
5. Remove remainder of switch assembly from the door.
6. To replace lamp transformer insert a screwdriver under the locking tabs on one side of the
transformer (4) and then on the opposite side. Reverse steps 1 thru 5.
7. To replace switch operator insert screwdriver under locking tabs at the front of the switch and
pry up. Do the same on the opposite side.
8. Install the operator. Reverse steps 1 thru 5.
9. Replace contact block (5).
1. Insert a small screwdriver in the slot at the rear of the contact block and separate the
blocks.
2. Slide the blocks forward and backward, do not attempt to pry apart laterally.
3. Assemble the new contact block (blocks) and insert the lamp holder from the front.
Apply sufficient force to push lamp holder into place.
10. Reassemble in reverse order.
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
2940 Hwy 14 W, Rochester, MN 55901
