Public Address System Digital Mixer Amplifier
5
General Installation
ALWAYS
ensure that the equipment is properly earthed (grounded). Operating
without an earth is dangerous and may cause high levels of audible hum from
the speaker outputs.
NEVER
remove the top cover of the amplifier or make an internal adjustment
with the ac mains supply connected. All internal servicing should be performed
by a competent and qualified engineer.
DO NOT
expose the unit to rain or moisture. If any fluids or foreign objects
should enter the unit, disconnect the power plug immediately.
DO NOT
site the equipment in locations exposed to direct sunlight, near
heaters or other heat sources. Avoid locations with high humidity or dust levels.
DO NOT
obstruct the ventilation slots in the amplifier case and allow adequate
ventilation. (Ensure that a 1U ventilation panel is fitted above the unit if the
amplifier is rack mounted.)
DO NOT
run microphone cables near mains, data, telephone or 100V lines.
AVOID
jointing the microphone cables if possible. If this is unavoidable, make
sure a good quality screened connector is used.
ALWAYS
use a balanced or floating low impedance microphone on long
microphone runs, terminating in a balanced input.
