ADS Technologies RedRover RDX-120, User Manual, Page: 5 / 13

6
Installing your Red Rover
1. Turn on your computer and load Windows normally.
2. Plug Red Rover into the computer’s USB port. USB-compatible
device detection messages will appear on screen. During this time
Red Rover’s LCD screen will read “Initializing…”
3. Under some Windows versions, the installation of Red Rover will
be completely automatic. When Red Rover is fully installed in
Windows, Red Rover’s LCD screen should read, “Red Rover (FW
1.x) / Remote Audio Control”. If Red Rover is installed automatically,
skip to step 9.
4. Some Windows versions will require your Windows CD to install
the Human Interface Device driver that Red Rover requires. If this
is the case, you will see a dialog that says, “This wizard searches for
new drivers for: USB Human Interface Device.” Click Next to
continue. (Note: some versions of Windows may have slightly
different wording in the installation dialogs. If this is the case, just
follow the on-screen instructions to complete installation.)
5. The next dialog will say, “What do you want Windows to do?”
Select, “Search for best driver for you device (recommended)” and
click Next.
6. Insert you Windows CD-ROM. If Windows setup runs, exit out of
the Windows setup screen. Select “CD-ROM drive” from the list of
locations, and click Next.
7. The next dialog will say, “Windows driver file search for the device:
USB Human Interface Device”. Click Next to install the driver.
8. The last dialog will say, “Windows has finished installing the software
that your new device requires”. Click Finish to complete the
installation of the driver for Red Rover. Red Rover’s LCD screen
should now read “Red Rover (FW1.x) / Remote Audio Control.”
9. Start your supported software (e.g. Adobe Audition, Cool Edit Pro 2.0
or higher, etc.) and set it to use Red Rover as its controller. See
your application specific help for more details on this step.
10. If you have any trouble installing Red Rover, visit
http://www.adstech.com for help.