initial state(zero throttle position), please check whether the roller is in the aero throttler
position.
4) switch direction of the skateboard
Go forward state ,touch keyboard A that the remote control shaking one time (the shaking time
be one second ),left bottom of the display screen displaying BW (GO BACK MODE ).
GO back state, touch keyboard A that the remote controller sharing one time, left bottom of the display screen
displaying FW( GO FORWARD MODE )
NOTICE:the operation is only for the remote control ,throttle and stick at the middle posting (zero throttle
position )
6)
switch gear
skateboard with 4 gears ;LO GEAR ; MI GEAR; HI GEAR; HI+ GEAR
LO limit speed be 0-10 km/h
MI limit the speed be 20-25 km/h
HI and HI+limit the speed be 40-45km/h
distinguish the HI is for comfortable mode and the HI+ is for player mode
under LO state. Touch the keyboard B that the remote control shakes one time , remote control display the
gear be MI (2 GEAR);
Under MI state, Touch the keyboard B that the remote control shakes one time , remote control display the
gear be HI(3 GEAR);
Under HI state, Touch the keyboard B that the remote control shakes one time , remote control display the
gear be HI+(4GEAR);
This operation is only effective if the roller is at the midpoint (zero throttle); And speciÞc gear speed can
be adjusted by speciÞc use of electrical regulation.
Charging
ɠ
remote control charging :after the remote control connect charging, remote control shakes one time, the
light is on of the USB port , display screen displaying at charging state.
NOTICE: can not operate any other operation under charging state, after 30s that the display screen will
automatic shutdown , push out the charger line that the remote control will short shaking one time then
automatic shutdown
ɡ
Battery charging : connecting charger under the skateboard be off state, skateboard turn into charging
state. Connecting charger under the skateboard be turn on state , turn into charging state then remote
display screen of remote control displays BO charging state) automatic shutdown after push out the
charger line .
NOTICE:under the charging state , skateboard can not connect remote control or connecting does not
accept any instruction. Under charging state that motor and part of controller stops working .
04
Fault warning instructions:
1
battery low voltage alarm
full power downhill overcharge alarm
In principle, we forbid the use of fully charged skateboards downhill,Because the downhill brake operation will
charge the battery, so full power downhill will cause skateboard battery life reduced or even an explosion Þre
accidents! Users need to consume a certain amount of electricity on the ßat road or uphill before downhill!
Note that the throttle is not in the initial state (zero throttle position), please check whether the roller is in the
zero throttle position.Analog stick
