measurement (ie, exceeding the pre-programmed "altitude of the start of measurement") is signaled
by double blink of diode. Current measurements are saved in memory. After a minimum of
2 seconds after the triggering of measurement altimeter verifies if the model is dropping. If it
reached the altitude of less than 7m, and the model will not get lower, 32 more measurements will
be taken, and the cycle is completed. The end is signaled by three blinks of LED (as in the absence
of zeroing). You can disconnect the battery and connect the altimeter to the computer to read data.
If the end of the measurements was not detected automatically, you must short the contacts for
a while (like the return to zero). The measurement is completed
8.
Reading of measurements.
After the flight, check if it has been measured. Start of measurement is indicated by two blinks
of the diode. The end of the measurement (detection of land level or the end of memory) is
indicated by a three blinks of LED. However, if after the flight the LED blinks twice, it means that
level of the landing has not been detected -
but the measurements were made. You can
disconnect the battery – until this time
measurements were recorded in the
memory. When connected to a computer,
the altimeter’s LED should blink three or
four flashes (this depends on the parameter
settings "reset manually - as described
above). This means that the measurement
was registered. After pressing the "Read
altimeter" measurements will be read and
displayed on the screen.
On the right side maximum and
minimum altitude will be displayed. In the
"contestant" window the number of
competitor and the serial number will be
displayed.
Read data can be saved on your computer HDD by pressing "Save" in the panel "Drive - Read /
write. Such recorded data can be played back at any time.
Altimeter does not need to be connected. The program can
read the current temperature
measured by the altimeter.
The
graph
can be
zoomed. Use your mouse
to
mark the interesting part
of the
chart. During zooming it is important to mark from
left to
right. Any selection from right to left returns to the
view
of the entire chart. Below are the charts after the increase.
Graphs of the flight can be compared with each other. To
do this, read data from altimeter or disk, and then click
"Compare". This brings up a file selection window. Please
select a file with data to compare and click 'Open'.
An additional chart appears on the screen. Speed chart and
comparisons can be switched off in the menu tab "Charts"
9
Summary of Contents for ALT-BMP
Page 1: ......