Intended nuse
• ADORA
®
top shower set with thermostatic mixer is manufactured to provide a shower with cold
water, hot water and mixed water for personal hygiene
Guaranty
• A 10-year guaranty is granted against drip and manufacturing defects. The guaranty
covers spare parts.
• The purchase receipt is the product guaranty certificate. Keep the receipt together with
the manual.
•
It is recommended to scan or copy the receipt, as printing ink may fade over time
Maintenance
• Mixers with chromed or colored surfaces and faucets in stainless steel must be wiped
immediately after use
• The temperature handle must be turned frequently to full hot and full cold position, this reduces
the risk of limescale in the thermostatic unit
• Stainless steel Mixers must be treated frequently with care products made especially for
stainless steel
• Stainless steel, which is not properly maintained, is likely to grow surface rust
• The top shower nozzles are to be rubbed daily, by hand or with a towel
• Top showers must be dismantled and descale regularly, at least every 3rd month.
• Top showers that break due to calcification are not covered by the guaranty
Cleaning
• Use only neutral detergents that are not abrasive or lime-soluble and do not contain acid,
chlorine, or phosphorus
• When using sprayable detergents; always spray the detergent on a cloth first and then
apply the cloth to the faucet. Direct spray on the faucet, gives a risk of damaging the rubber
rings and other vital parts
• Never use abrasive vapors or scouring sponges on faucets
• Stainless steel faucets must be cleaned frequently with detergents made especially for
stainless steel
Installation
ADORA® faucets shall be mounted in a legal installation and in accordance with applicable laws
of the country in which the faucet is mounted. If there is any doubt about the correct installation,
contact an authorized plumbing installer.
The operating pressure of the installation must be between 1 and 6 bar. At higher operating
pressures, pressure reduction valves must be installed on both cold and hot water connections.
The mixers factory settings are done at 3 bar pressure on hot and cold water.
If the faucet drips or does not work immediately after installation:
1.
Leave the faucet installed and shut off the water supply
2.
See the ‘Questions & Answers’ section in this manual
3.
For more information go to www.adora-design.com or write to:
Remember to attach some photos of the installed product. Furthermore, a copy of the purchase
receipt and if possible, the installation receipt.
2
