BIOS Setup
41
RB-850
.
Serial Port Mode
Select the baud rate you want the serial port to use for console
redirection. The options are
115200 8,n,1
;
57600 8,n,1
;
19200 8,n,1
; and
09600 8,n,1
.
Flow Control
Set this option to select Flow Control for console redirection.
The settings for this value are
None
,
Hardware
, or
Software
.
Redirection After BIOS POST
This option allows you to set Redirection configuration after
BIOS POST. The settings for this value are
Disabled
,
Boot
Loader
, or
Always
.
X
Disabled:
Set this value to turn off the redirection after POST
X
Boot Loader:
Set this value to allow the redirection to be
active during POST and Boot Loader.
X
Always:
Set this value to allow the redirection to be always
active.
Terminal Type
This option is used to select either VT100/VT-UTF8 or ANSI
terminal type. The settings for this value are
ANSI
,
VT100
, or
VT-UTF8
.
VT-UTF8 Combo Key Support
This option enables VT-UTF8 Combination Key Support for
ANSI/VT100 terminals. The settings for this value are
Enabled
and
Disabled
.
Sredir Memory Display Delay
This option gives the delay in seconds to display memory infor-
mation. The options for this value are
No Delay
,
Delay 1 Sec
,
Delay 2 Sec
, or
Delay 4 Sec
.
NOTE:
NOTE:
If you have changed the resource assignment of the serial ports in
Advanced> SuperIO Configuration, you must Save Changes and
Exit, reboot the system, and enter the setup menu again in order to
see those changes reflected in the Remote Access options.
