Getting Started
23
3
Getting Started
This chapter gives a summary of what is required to setup an
operational system using the NuPRO-851. Hardware installation
and BIOS overview is discuss.
3.1 CPU Installation
X
Disengage Load Lever by depressing down and out on the
hook to clear retention tab. Rotate Load Lever to fully open
position at approximately 135°
X
Rotate Load Plate to fully open position at approximately
100°. Remove Socket Protective Cover. With left hand
index finger and thumb to support the load plate edge,
engage protective cover finger tab with right hand thumb
and peel the cover from LGA775 Socket while pressing on
center of protective cover to assist in removal.
X
Locate two orientation key notches.
X
Grape processor with thumb and index finger. (Grasp the
edges without the orientation notches.) The socket has cut-
outs for your fingers to fit into. Carefully pace the package
into the socket body using a purely vertical motion. (Tilting
the processor into place or shifting it into place on the
socket can damage the sensitive socket contacts.)
X
Verify that package is within the socket body and properly
mated to the orientation keys
X
Close the socket by:
1. Close the Load Plate.
CAUTION:
Do not touch socket sensitive
contacts. We assume no
responsibility for the potential
damages caused by this action and
therefore the warranty we provide
may be invalid.
Summary of Contents for NuPRO-851
Page 4: ......
Page 10: ...2 Introduction 1 1 NuPRO 851 Block Diagram Figure 1 1 NuPRO 851 Block Diagram ...
Page 14: ...6 Introduction 1 3 NuPRO 851 Mechanical Drawing Figure 1 2 NuPRO 851 Mechanical Drawing ...
Page 15: ...Introduction 7 1 4 NuPRO 851 Components and Connectors ...
