ADLINK Technology HPERC-IBR-MC, User Manual

Page: 23 / 53

HPERC-IBR-M Setup 13
HPERC-IBR-M
Table 1-5: I/O Panel Connectors
(Refer to Figure 1-7 for connector locations.)
1.15 P1 Military DC Power In Connector
The following diagram and table define the signals and signal maps of the P1 military DC power
in connector.
Figure 1-8: P1 Military DC Power In Connector Pin Locations
Control/Connector Description
P1 DC Power In This Military Power connector accepts DC voltages from an external
source.
NOTE
: This connector is manufactured by Amphenol.
P2 Military Connector This military connector provides signals for Ethernet Ports, USB 2.0,
Serial Ports, Reset Switch, Ethernet LEDs, Power LED, SATA Activity
LED, UNDIO, Power Switch, Audio In/Out.
P3 Military Connector This military connector provides signals for VGA, Ethernet LEDs,
Ethernet Ports, Serial Ports, PS/2 Keyboard and Mouse, DVI, USB 2.0.
L1/L2 LEDs Both LEDs light amber to indicate that the system is powered on
(programmable functionality is reserved for future revisions).
NOTE
: To connect an external Hard Disk Drive (HDD) or CD-ROM to the HPERC-IBR-M,
use one of the USB or SATA ports to connect the device.
P1 Pin Signal
A V+
B V+
C Ground
D Ground
Table 1-6: P1 Military DC Power In Connector Signals
GND V+
GND V+
GND V+
GND V+
A
D
B
C
HPERC_DC_In_Pinout_b