ADLINK Technology cPCI-6841 Series, User Manual

Page: 52 / 76

42 Getting Started
on the operational purpose of the board. The chassis
power may now be turned on.
2. Remove the blank face panel from the slot.
3. Align the top and bottom edges of the board with the
card guides on the chassis then slide the board into the
chassis until resistance is felt. If the system power is on,
the green LED (power status) will light up.
4. Move the upper and lower ejectors in an inward direction
simultaneously. Note that a slight resistance will be felt
while inserting the board. If this resistance is more than
normal, check to ensure that there are no pins bent on
the backplane and that the board’s connector pins are
aligned properly with the connectors on the backplane.
5. Secure the two screws hidden behind the upper and
lower ejector; connect the necessary cables to the
board.