CONTROLS AND FUNCTIONS -
WiTECH8 RECEIVER:
1. Power Sockets (UK or Schuko) -
8 power jacks provide power to 8 units.
2.
Power Switch
- This switch powers on the WiTECH8 Receiver.
3.
Antenna
- Receives the signal from the WiTECH8 Controller.
4.
6,3mm Jack
- Connect your desired compatiable fixture to this jack.
5-6.
LED Outputs
- These LED’s will glow indicating activity. Example, the Stand By LED will glow
when the unit is in Stand By mode.
7.
Set Up Button
- Press this button to set up the receiver.
8.
RF Signal LED
- This LED will glow when the Set Up button has been pressed.
9.
Power Cord
- Plug this power cord into a compatible voltage power source to power the
WiTECH8.
10.
Fast Lock Hook -
This bracket is used to hang the WiTECH8
from trussing. See picture at the side.
WiTECH8 CONTROLLER:
11.
RF Signal LED
- This LED will blink when a command from the controller has been sent to
the receiver.
12.
All Off Button -
Hold this button for at least 5 seconds to turn off all the fixtures that are
plugged into the power sockets.
13.
All On Button -
Hold this button for at least 5 seconds to turn on all the fixtures that are
plugged into the power sockets.
14.
Stand By Button -
Puts the fixture connected to the 1/4” jack into blackout mode.
15.
Function Button -
This button lets you select different functions. Please see the user manual
of your connected fixture for UC3 programs and functions.
16
Mode Buttons -
This button lets you select different functions. Please see the user manual
of your connected fixture for UC3 programs and functions.
17.
Power Jacks On/Off Button -
This button activates and deactivates all of the power jacks.
Hold this button for at least 5 seconds to activate the power jacks.
WiTECH8 RECEIVER
WiTECH8 CONTROLLER
