American DJ
®
- www.americandj.com - Vizi Beam 5R™ Instruction Manual Page 20
American DJ
®
- www.americandj.com - Vizi Beam 5R™ Instruction Manual Page 19
Vizi Beam 5R™
System Menu
On-Board System Menu.
The Vizi Beam 5R™ comes with an easy
to navigate system menu. This next section will detail the functions of
each command in the system menu.
To access the main menu press the MODE/ESC button
(3)
on the front
of the unit. Tap the UP
(4)
or DOWN
(5)
butons until you reach func-
tion you wish to change. When you reach the function you wish to
change tap the ENTER
(6)
button
.
Again, tap the
UP or DOWN buttons
to change the function. Once your changes are made, tap the ENTER
button
to lock the change in the system, if the ENTER button
is not
selected within eight seconds the system will automatically return to
menu section. To exit without making any changes tap the MODE/ESC
button.
ADDR
MENU -
ADDR
DMX Address Setting
via control board -
1. Access the main menu.
2. Tap the UP button until “
ADDR
” is displayed, press ENTER.
3. “
A001
” will now be displayed. Press the UP or DOWN buttons
to find your desired address. Press ENTER to confirm.
4. The display will show “
PASS
”, and then display, your selected
address again.
5. Press the MODE/ESC button to return to the main menu.
When the display is on
“
A001
”,
you can directly press the UP
or DN buttons to change the DMX start address.
TEST
MAIN MENU -
TEST
- This will test the functions of each channel.
1. Access the main menu.
2. Tap the UP button until “
TEST
” is displayed, press ENTER.
3. The display will show “
T-01
”. You can now press the up
Vizi Beam 5R™
System Menu
react to any control signal.
DLAY -
With this function you can put the lamp on a delay time.
SPOT -
This provides a spot beam for better lamp optimization.
DFSE -
This will reset the unit to the default settings.
FEED -
With this function you can activate or deactivate the
pan/tilt error correction. So if you units head gets knocked out
of place the unit will automatically go back to the last setting.
FANS
- Select the fan run mode.
HIBE -
This feature will automatically shut down the lamp and
stepping motors. Please see page 33.
VER -
This will display the software version.
ADJU
- Fixture code is “C050”.
CH01~CH30 for motor calibration.
EDIT MENU -
SEPR
(AUTO or IP01 - IP07) - Lets you edit any of the 7 internal
programs or auto program.
STEP
(Step) - Steps to be used in Edit Programming. See ediit
program. See page 35.
SCXX
(SC01 - SC48) - These are the scenes that are stored in
your program. There are a total of 48 scenes.
Submenus:
C-01~C-30 - Edit the channels of each scene.
TIME - Set the Time for each scene.
CEDT - Edit the program via external controller.
REC
- This will auto save your custom program.
RUN
- This will run your custom program.
