ADJ Products, LLC - www.adj.com - Ultra Hex Bar 6 User Manual Page 12
Master-Slave Configuration:
This function will allows you to link units together to run in a Master-
Slave mode. In Master-Slave operation one unit will act as the con-
trolling unit and the others will react to the controlling units built-in
programs. Any unit can act as a Master or as a Slave however, only
one unit can be programmed to act as the “Master.”
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the
unit. Use standard XLR data cables to link your units together.
Remember that the Male XLR connector is the input and the
Female XLR connector is the ouput. The first unit in the chain
(master) will use the female XLR connector only. The last unit in
the chain will use the male XLR connector only.
2. Set the “Master” unit to your desired mode of operation.
3. Connect the first “Slave” unit to the “Master.”
4. On the “Slave” unit set it to the DMX MODE setting. The “Slave”
unit will now follow the “Master”.
Ultra Hex Bar 6 Master-Slave Configuration
ADJ Products, LLC - www.adj.com - Ultra Hex Bar 6 User Manual Page 11
tion (On) or deactivate it (Off).
DMX State:
This mode can be used as a precaution mode, that in case the DMX
signal is lost, the operating mode chosen in the setup is the running
mode the fixture will go into when the DMX signal is lost. You can also
set this as the operating mode you would like the unit to return to when
power is applied.
1. Press the MODE button until “DMX MODE” is displayed.
2. Press the SET UP button so that “NO:XXXX” is displayed. “XXXX”
represents the current DMX state that is displayed.
• “NO: BLACK” (Blackout) - If the DMX signal is lost or interrupted,
the unit will automatically go into stand by mode.
• “NO: HOLD” (Last State) - If the DMX signal is lost or interrupted,
the fixture will stay in the last DMX set up. If power is applied and
this mode is set, the unit will automatically go into the last DMX set
up.
• “NO: AUTO” (Auto Run) - If the DMX signal is lost or interrupted,
the unit will automatically go into Auto Run mode.
3. Use the UP and DOWN buttons to find your desired DMX state
and press SET UP to confirm and exit.
Dimmer Curve:
This is used to set the dimming curve used with DMX mode. See
page 20 for the different dimming curves.
1. Plug the fixture in and press the MODE button until “DMX MODE”
is displayed.
2. Press the SET UP button until “DELAY: X” is displayed. “X” repre-
sents the displayed dimmer curve (0-4).
• 0 - Standard
• 1 - Stage
• 2 - TV
• 3 - Architectural
• 4 - Theatre
3. Press the UP or DOWN buttons to scroll through and select your
desired dimming curve.
Ultra Hex Bar 6 Operating Instructions
