ADJ Products, LLC - www.adj.com - Pixie Strip 30 / 60 / 120 User Manual Page 8
Pixie Strip 30 / 60 / 120
Installation
FLAMMABLE MATERIAL WARNING!
Keep drive a minimum of 5.0 feet (1.5m) away from flammable material and/or pyrotechnics.
ELECTRICAL CONNECTIONS
A qualified electrician should be used for all electrical connections and/or installations.
DO NOT INSTALL THE DEVICE IF YOU ARE NOT QUALIFIED TO DO SO!
The device MUST be installed following all local, national, and country commercial electrical and
construction codes and regulations.
Before rigging or mounting a single fixture or multiple interconnected fixtures for custom matrix
designs to any metal truss or structure or placing the fixture(s) on any surface, a professional equip-
ment installer MUST be consulted to determine whether the metal truss, structure, or surface is
properly certified to safely support the combined weight of the fixture(s), clamps, cables, and any
other accessories.
Fixture(s) should be installed in areas outside walking paths, seating areas, or away from areas
where unauthorized personnel might be able to reach the device by hand.
NEVER stand directly below the fixture(s) when rigging, removing, or servicing. Overhead fixture
installation must always be secured with a secondary safety attachment, such as an appropriately
rated safety cable (not included) that meets all local, national, and country codes and regulations.
Allow approximately 15 minutes for the fixture to cool down before servicing.
SOCKET PIN CONFIGURATION
This device features two (2) output sockets on the back side, which may be used to connect the
device to the desired lighting fixtures. The pins for each output socket are configured as shown in
the image below. Please consult a qualified electrician for all electrical connections and/or
installations.
Pin 1: Power (+)
Pin 2: Data
Pin 3: CLK (clock pin)
Pin 4: Power (-)
