ADJ PIN363, User Manual

Page: 11 / 16

11
O P E R AT I N G I N S T R U C T I O N S
Energy Saving Mode:
There are 3 methods that can be used to set this fixture to energy saving mode. When the fixture is
set into energy saving mode, it will decrease the LED brightness gradually when the battery life falls
below 80% in order to extend the battery life. NOTE: When the unit is using DC power, the energy
saving mode cannot be used.
• When operating the fixture from the built-in control panel, press and hold the MODE button for 5
seconds to switch between normal mode and energy saving mode.
• When using the ADJ UC IR, press and hold the STAND BY button for 5 seconds to switch be-
tween normal mode and energy saving mode.
• When using the ADJ LED RC3, press and hold the BLACKOUT button for 5 seconds to switch
between normal mode and energy saving mode.
• Regardless of the method used to select the fixture’s operating mode, the fixture’s LED will flash
3 times to indicate that the fixture is in normal mode, or the LED will flash continuously for 5 sec-
onds to indicate that the fixture is in energy saving mode.
Low Battery Warning:
When the battery power falls below 30%, the LED will alternately flash rapidly for 5 seconds each
time the power is switched ON. After the 5 seconds, the unit will function normally. The device does
this to inform the user that charging is required.
Battery Recharge:
To recharge the battery, use the included DC power supply to connect the plug on the rear of the
fixture to a power source of the correct voltage. The fixture requires about 6.5 hours to charge from a
fully depleted state to full charge with the power switch off.
Operating Power:
There are two ways to supply power to this unit: battery power or DC power.
• DC Power - To run the unit using DC power, plug the unit into a DC power source, and set the
POWER switch in the ON position.
• Battery Power - To run the unit using Battery power, set the POWER switch in the ON position.
Mode Button Lock:
The MODE button will lock itself after 30 seconds of inactivity. To unlock the unit, press and hold the
MODE button for 3 seconds.
Mode Operation:
Each press of the MODE button will cycle through the different operating modes. The operating
modes are listed below in the order in which the unit cycles through them. Please note: When power
is turned OFF and turned back ON, the unit will start in the last operating mode.
• Order of Operating Modes: 100% Brightness > 95% > 90% > 84% > 78% > 72% > 66% > 60% >
54% > 48% > 42% > 36% > 30% > 24% > 18% > 12% > 6 % > LED Off > Fast Fade > Slow Fade
Pressing the MODE button again after “Slow Fade” will return the unit to the first setting.