Operation Guide
6
To copy a scene
Enter the Programing mode.
(1)
Select your desired being copied scene in a bank.
(2)
Press Midi/Rec button.
(3)
Press your selected Scene button in the relevant bank, all LEDs flash briefly, that
means your copy operating has been saved.
(4)
To delete a scene
Enter the Programing mode.
(1)
Select a scene to be deleted.
(2)
Press and hold down the DEL button, and at the same time, tap your selected
Scene button, all LEDs will flash briefly, that means the scene has been deleted.
(3)
To delete all the scenes
Before turning on the power, you press and hold down the Program button and the Bank
Down button, and then turn on the power at the same time, all LEDs flash briefly, this just
means all the scenes have already been deleted.
Scene Playback
When powered on, this unit will be firstly in the Manual control mode, and all channel
outputs are in black-out state (the Blackout LED flashes at the display window).
(1)
Tap the Blackout button (Blackout LED goes out) to enable the channel output.
(2)
Tap the AUTO button, the Auto Trigger LED will light up at the display window, this
indicates you that you are now in the Auto trigger mode.
(1)
Tap Bank Up/Down button to select desired bank (0~30).
(2)
You can use the Speed fader (or Tap/disp button) and the Fade Time fader to adjust
the running state.
(3)
1. Manual trigger:
Select your desired scene to be replayed, tap this scene button to enable the scene
(Tap this scene button again to disable the scene).
(3)
2. Auto trigger:
Tap the Auto button again(Auto Trigger LED goes out) to exit from the Auto mode.
(4)
Note: You can tap the Tap/Disp button twice to create an interval running rate.
Operation Guide
5
When powered on, this unit will be firstly in the Manual control mode, and all channel
outputs are in black-out state (the Blackout LED flashes at the display window). You
can also press the Blackout button to enable the channel output.
To record a scene
Enter the Programing mode as the above told you.
(1)
Press a Fixture button, its LED will be lit.
(2)
Press and hold down the Program button for about 2 seconds till the PROG LED flashes,
this means you have entered the programing mode. Press and hold down the Program
button for about 2 seconds again (till the PROG LED goes out) to exit from the Program-
ing mode.
Use the channel faders to set a scene (You can use the Channel Bank button to
select between Ch1~8 and Ch9~16 as your desire).
(3)
Then press the REC button to record the scene that you have set.
(4)
Select a bank (01~30).
(5)
Select a Scene button (1~8) in this bank and press it, all LEDs flash briefly, this
means you setting has been saved.
(6)
Set the other scene(s) in the same way as your desire.
(7)
After finishing your settings, you can press and hold down the Program button for
about 2 seconds (till the PROG LED goes out) to exit from the Programing mode.
(8)
Note: The recorded scene can be reedited; if you reedit a scene and save it, the old
scene will be replaced by the new one.
Scene Operation
To edit a scene
Enter the Programing mode.
(1)
Select your desired being edited scene in a bank.
(2)
Press a Fixture button (its LED lights up), and then set a new scene.
(3)
Press Midi/Rec button, and then press the selected scene button (all LEDs flash
briefly, that means your setting has been saved).
(4)
