ADJ Products, LLC - www.adj.com - Jellyfish IR Instruction Manual Page 10
ADJ Products, LLC - www.adj.com - Jellyfish IR Instruction Manual Page 11
Jellyfish IR
System Menu
mode the fixture will go into when the DMX signal is lost. You
can also set this as the operating mode you would like the
unit to return to when power is applied.
1. Press the MENU button until “
DNST
” is displayed, and either
“
MASL
” or “
BLND
” will be displayed beneath.
2. Press ENTER and the bottom choice will begin to flash. Use
the UP or DOWN buttons to choose an operating mode you
would like the unit to start up in when power is applied or the
DMX signal is lost.
•
MASL
(Master Slave) - If the DMX signal is lost or power is
applied, the unit will automatically go into Master Slave mode
and run a built-in show.
•
BLND
(Blackout) - If the DMX signal is lost or interrupted, the
unit will automatically go into stand by mode.
3. Press ENTER to confirm your desired set up.
LED -
With this function you can have the LED display
turn off after 10 seconds.
1. Press the MENU button until “LED” is displayed, press
ENTER.
2. The display will show either “ON” or “OFF”. Press the UP or
DOWN buttons to select “ON” to keep the LED display on at
all times, or “OFF” to switch to have the LED display switch off
after 10 seconds.
3. Press ENTER to confirm.
IDSP
-
This function will reverse the display 180º.
1. Press the MENU button until “IDSP” is displayed, press
ENTER.
2. Press ENTER to “flip” the display. Press ENTER to “flip” it
again. Press ENTER when you have made your desired setup.
Jellyfish IR
System Menu
Sh 0
-
Sh 11
- Show modes 0 - 11 (Factory programs).
Show mode can be run with sound activity or without. For show
mode to run without sound activity turn sound activity off.
1. Press the MENU button until “ShNd” is displayed, press
ENTER.
2. “Sh X” will now be displayed, “X” representing a number
between 1-11. Programs 1-11 are factory programs, while “Sh
0” is random mode. Press the UP or DOWN buttons to find your
desired show and press ENTER to confirm.
SOUN -
Sound Active mode.
1. Press the MENU button until “SOUN” is displayed, press
ENTER.
2. The display will show either “ON” or “OFF”. Press the UP or
DOWN buttons to select “ON” to activate sound active mode,
or “OFF” to deactivate sound active mode.
3. Press ENTER to confirm.
SENS -
In this mode you can adjust the sound sensitiv-
ity.
1. Press the MENU button until “
SENS
” is displayed, press
ENTER.
2. A number between 0-100 will be displayed. Press the UP or
DOWN buttons to adjust the sound sensitivity. 0 being the least
sensitive, and 100 being the most sensitive.
3. When you have found your desired setting press ENTER to
confirm.
DNST
- This mode can be used as a precaution mode,
that in case the DMX signal is lost, interrupted, or power is
lost, the operating mode chosen in the setup is the running
