ADJ Avante Imperio, User Manual

Page: 14 / 34

Avante • Los Angeles, Ca USA • Mexico • Kerkrade, The Netherlands
14
O V E R V I E W – C O N N E C T I O N S & C O N T R O L S : S U B 2 1 0
IMPERIO SUB210
1. FUSE: Slow-Blow 8.0 Amp 250V fuse for 100-120V / Slow-Blow 4.0 Amp 250V fuse for 220-240V.
2. LEVEL: Speaker volume control.
3. LINE IN: 3pin XLR input connector (balanced line-level audio input).
4. SIG/LIMIT: Green indicates a signal ³ 25dBu, and red indicates that the internal limiter circuit has tripped,
preventing amplifier distortion and speaker overloads.
5. POWER: Blue indicates main power.
6. CROSSOVER: High pass filter sends high frequency content to the outputs. The lower frequencies under
the crossover point will be played by the internal speaker in the subwoofer (selectable 90Hz/120Hz).
7. OUTPUT MODE: Switches between the internal CROSSOVER and LINK modes. When set to
CROSSOVER, the XLR jacks send the input signal to the built-in crossover, allowing you to select the
crossover frequency. The output signal should then be used to play the filtered frequencies with your
standard full frequency speakers (IMPERIO). When set to LINK, the crossover function is disabled.
8. OUTPUT: 3pin XLR output connector (balanced line-level audio output or CROSSOVER).
9. SUBWOOFER PHASE: Phase switch alters the polarity of the input signal between “0°” and “180°”. When
the phase switch is set to “0°,” phase is unaffected.
10. MAINS LINK: power output (-). Output is connected in parallel with input (11) and can be used to power
additional IMPERIO speakers.
11. MAINS INPUT: Power input (+).
4
5 6
7
3
9
8
2
11
10
1
11
10
1
120V Silkscreen
240V Silkscreen