ADJ Products, LLC - www.adj.com - 3D Vision Instruction Manual Page 4
ADJ Products, LLC - www.adj.com - 3D Vision Instruction Manual Page 5
•
To reduce the risk of electrical shock or fire, do not expose this unit
rain or moisture
•
Do not spill water or other liquids into or on to your unit.
•
Be sure that the local power outlet match that of the required volt-
age for your unit.
•
Do not attempt to operate this unit if the power cord has been
frayed or broken. Do not attempt to remove or break off the ground
prong from the electrical cord. This prong is used to reduce the risk
of electrical shock and fire in case of an internal short.
•
Disconnect from main power before making any type of connection.
•
Do not remove the cover under any conditions. There are no user
serviceable parts inside.
•
Never operate this unit when
it’
s cover is removed.
•
Never plug this unit in to a dimmer pack
•
Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about
6”
(15cm) between this device and a wall.
•
Do not attempt to operate this unit, if it becomes damaged.
•
This unit is intended for indoor use only, use of this product out`
doors voids all warranties.
•
During long periods of non-use, disconnect the
unit’
s main power.
•
Always mount this unit in safe and stable matter.
•
Power-supply cords should be routed so that they are not likely to
be walked on or pinched by items placed upon or against them,
paying particular attention to the point they exit from the unit.
•
Cleaning -The fixture should be cleaned only as recommended by
the manufacturer. See page 9 for cleaning details.
•
Heat -The appliance should be situated away from heat sources
such as radiators, heat registers, stoves, or other appliances (inclu-
ding amplifiers) that produce heat.
•
The fixture should be serviced by qualified service personnel when:
A.The power-supply cord or the plug has been damaged.
B.
Objects have fallen, or liquid has been spilled into the appliance.
C.
The appliance has been exposed to rain or water.
D.
The appliance does not appear to operate normally or exhibits a
marked change in performance.
Control Using a DMX Controller:
1. The 3D Vision has 9 DMX channels. See page 11for detailed
description of the DMX values and traits. See the page 7 for the
pixel layout.
1.
To set a DMX address you will need to use the 3D Vision Encoder
(Sold Separately). Follow the instructions included with your 3D
Vision Encoder to set your desired DMX address.
2.
When connecting to a DMX controller or using MyDMX, you will
need to use a RJ45 to 3pin adapter. This can be purchased
through ADJ.
3.
Connect the first unit to the adapater and then connect to either
your DMX controller or MyDMX.
4.
Follow the DMX traits on page 11 to control your unit.
Do not
daisy-chain more than 32 Panels when connecting directly
to a DMX controller.
3D Vision
Operation
3D Vision
Safety Precautions