ADJ Products, LLC - www.adj.com - 3 Sixty 2R Instruction Manual Page 31
ADJ Products, LLC - www.adj.com - 3 Sixty 2R Instruction Manual Page 30
3 Sixty 2R
System Menu
3 Sixty 2R
System Menu
exit.
Mic Sensitivity - With this function you can set the microphone
sensitivity. The default setting is 70%. You can adjust the sensitivity
between 0%-99%
1. Press the MODE/ESC button to access the main menu. Press the
UP or DOWN buttons so that “Personality” is highlighted, then press
ENTER.
2. Press the UP or DOWN buttons until “Status Settings ” is dis-
played, press ENTER.
3. Press UP or DOWN buttons, until “Mic Sensitivity” is displayed,
and press ENTER.
4. “70%” will be displayed, use the UP and DOWN buttons to adjust
the sensitivity between 0%-99%.
5. Press ENTER to confirm your selection or press MODE/ESC to
exit.
Hibernation - With this function the lamp and step motors will power
off if there is no DMX signal within 15 mins (factory defualt). Once it
receives a DMX signal, the fixture will reset itself.
1. Press the MODE/ESC button to access the main menu. Press the
UP or DOWN buttons so that “Personality” is highlighted, then press
ENTER.
2. Press the UP or DOWN buttons until “Status Setting” is dis-
played, press ENTER.
3. Press UP or DOWN buttons, until “Hibernation” is displayed, and
press ENTER.
4. “15M” will be displayed, use the UP and DOWN buttons to adjust
the hibernation period between 01M-99M or “Off”.
5. Press ENTER to confirm your selection or press MODE/ESC to
exit.
Service Setting
Password - With this function you can enter the RDM password so
that you can access and change the RDM ID number.
1. Press the MODE/ESC button to access the main menu. Press the
UP or DOWN buttons so that “Personality” is highlighted, then press
ENTER.
2. Press the UP or DOWN buttons until “Service Setting” is dis-
played, press ENTER.
3. Press UP or DOWN buttons, until “Password” is displayed, and
press ENTER.
4. The “Password” is 050.
5. Press ENTER or press MODE/ESC to exit.
RDM PID - RDM stands for “Remote Device Management”. This
feature lets you control every aspect of your fixture remotely from an
RDM controller. Manual settings like adjusting the DMX address are
no longer needed. This is especially useful when the unit is installed
in a remote area.
In this submenu you can see the units RDM ID number and adjust it
as well.
1. Press the MODE/ESC button to access the main menu. Press the
UP or DOWN buttons so that “Personality” is highlighted, then press
ENTER.
2. Press the UP or DOWN buttons until “Service Setting” is dis-
played, press ENTER.
3. Press UP or DOWN buttons, until “RDM PID” is displayed, and
press ENTER.
4. “XXXXXX” will be displayed. “XXXXXX” represents the units current
RDM ID.
5. Press ENTER or press MODE/ESC to exit.
Display Setting
Shutoff Time - With this function you can have the LCD display after
2-60 minutes. Use this function to adjust the time.
1. Press the MODE/ESC button to access the main menu. Press the
UP or DOWN buttons so that “Personality” is highlighted, then press
