
ADJ Products, LLC - www.adj.com - Vizi Wash Z37 User Manual Page
4
2
Vizi Wash Z37
System Menu
DMX SETTINGS - The submenus listed under DMX SETTINGS are as follows: DMX Address, DMX
Channel Mode, and No DMX Status.
- DMX ADDRESS - In this submenu you can find and set your desired DMX address.
- DMX CHANNEL MODE - In this submenu you can find and set your desired DMX channel mode.
- NO DMX STATUS - This submenu setting is used as a precaution mode in case the DMX signal is
lost or interrupted. The operating mode chosen in this submenu is the running mode the fixture
will go into when the DMX signal is lost. Listed below are the 4 modes.
• Hold Last -This setting will have the fixture stay in the last DMX setup.
• Blackout - This setting will have the fixture automatically go into stand by mode (blackout).
• Int (Internal) Program - This setting will have the fixture run an internal program.
• Manual -This setting will have the fixture automatically go to the setup made under the “Manual
Control” menu.
PERSONALITY - The submenus listed under PERSONALITY are as follows: Status Settings, Fan
Settings, Dim Modes, Gamma, Reset Motors, Display, and Service.
- STATUS SETTINGS - In this submenu you are able to access and adjust/change the Pan Invert,
Tilt Invert, P./T. Feedback, P./T. Speed, and Hibernation.
- FAN SETTINGS - In this submenu you are able to select your desired fan speed settings for both
the head and base fans.
- DIM MODES - In this submenu you are able to select your desired dimmer mode and adjust the
dimming speed time.
- GAMMA - In this submenu you are able to select your desired gamma setting.
- RESET MOTORS - In this submenu you are able to reset selected motors.
- DISPLAY - In this submenu you are able to access and adjust/change the backlight intensity, display
inversion, screen saver display time, and display lock function.
- SERVICE - In this submenu you are able to access the effect calibration, USB port power on/off,
software update, and restore the factory settings. NOTE: Please contact ADJ customer service
for instructions on updating software.
MANUAL CONTROL - This menu is for manual testing and manual control. All adjustments and
settngs made under this menu will be reflected under the “Manual” setting in the “NO DMX
STATUS” submenu. NOTE: For Manual Control to work “NO DMX STATUS” must be set to
“MANUAL”.