8
5.0 Hardware Setup
Device Mode (USB3.0 to SATA External Dual Hard Drive)
• Install your SATA hard drive properly to the port connector on the docking station
• Connect the docking station to your computer by USB cable
• Connect the power adapter to the enclosure and power up the docking station
• The computer should now detect the new hardware .
For Win 7/8/8.1/10, no driver setup is necessary .
Please Proceed to step 6.0 to format your drive.
Duplicator Mode
• Install 2 hard drives into the dock. Make sure to place the drive with the data you want
copied (Source) into the “Source” bay. The target disk (Target) should be equal or larger in
capacity than the source disk.
• Connect the power adapter to the enclosure and press the POWER button to power up
the docking station.
• After about 10 seconds, keep pushing the CLONE button for 3 seconds to begin
duplication. Clone Progress indicator(25%,50%,75% and 100%, 4 status) would be
acted.
Green LED flash: 25%
Red LED flash: 50%
Yellow LED flash: 75%
Orange LED flash: 100%
Green, Red, Yellow, Orange LED all on: Finish
Note: Can’t connect the docking station to your computer by USB cable for duplicator
mode.
6.0 Format your Hard Drive
(If the drive already appears in “My Computer”, Please skip to 6.2)
6.1 For an un-partitioned or un-formatted new drive , it normally does not automatically
appear in “My Computer” the first time. Please follow these steps:
For Win 7/8/8.1/10
• Right key of Mouse beat ”My computer”, Choose “Manager” choose “Disk manager”
of the list.