19
5.
Release the catch (4) of the rubber blade
clamp and take the rubber off to turn it to a
new side or replace it.
6.
Check that the coupling and the squeegee
hose are not obstructed and if necessary,
clean the entire assembly.
To reassemble the squeegee reverse the
operations above.
FRONT SQUEEGEE RUBBER REPLACEMENT
Check the wear of the front squeegee rubber and
replace it if worn out.
For the replacement it is necessary to:
1.
Lower the squeegee by lowering the handle
lever (5) placed in the centre of the handle
bar.
2.
Tip over the machine backwards (see under
“VERTICAL POSITIONING OF THE MACHINE")
remembering to switch off the on/off
switch and to empty the tanks.
3.
With the machine in this position take off
the squeegee and then the rear squeegee
rubber (see under “REAR SQUEEGEE RUBBER
REPLACEMENT”).
4.
Take off the wing nuts (6) in the upper part
of the squeegee body, separate the two
metal parts that form the squeegee body to
take off the front rubber.
5.
Clean all the components with water.
To reassemble the squeegee reverse the
operations above.
TROUBLESHOOTING GUIDE
THE SUCTION MOTOR DOES NOT WORK
1.
Check the charge level of the batteries that
is visible when switching on (1) (see under
“BATTERY CHARGING”).
2.
Verify that the suction motor switch (3) is
activated checking that its signal lamp is on.
3.
Check the level in the recovery tank (see
under “OVERFILL PROTECTION”) and if
necessary, empty the tank.
Summary of Contents for baby
Page 22: ...22...
