Setup Continued
Assemble Syringe:
If your adhesive is supplied in a pre-filled 10ml syringe,
please skip this step.
When using our industrial syringe barrels, take an empty
10ml size and attach a luer lock tip cap seal.
Fill the syringe with your adhesive or paste. Take care not
to overfill because material will ooze from the tip when the
tip cap is removed.
Insert the white piston (part 7100009WPK). The open side
faces out of the barrel so the flat side pushes against the
liquid when under pressure. Push the piston down so that
is sits flat on the adhesive level without any air gaps. Any
air gaps in the barrel may cause drips and ooze later on.
Attach Filled Barrel to Gun:
Align the barrel flange to the
gun flange. Push over rod end
and over o-ring seal. Push all
the way and then twist the
barrel anti-clockwise.
With the barrel attached, squeeze the gun trigger gently
until it moves down to the level of the piston.
Remove the tip cap from the tip end of the 10cc barrel.
This will expose a male luer lock thread on the barrel
ready to accept any of our dispensing tips.
Attach a tip and twist onto the barrel clockwise into
place. Select from standard tips to brush types, tapered
style and roller flexible tips.
Hold the gun and position the tip above the area
to be dispensed to. Squeeze the trigger to make a
deposit. Release the trigger to stop. For the best
results, touch the tip to the surface of the part,
make deposit then release trigger before moving
the gun away. This will release all the fluid to
the part and not carry over or spill from the tip
when finished. Ensure the piston does not have
an air gap between the fluid or it might drip.
6