ADF Web HD67F02-2-B2 MHz Series, User Manual

Page: 20 / 33

Industrial Electronic Devices
ADFweb.com S.r.l.
User Manual Modbus Slave / LoRaWAN Gateway
Document code: MN67F02_ENG Revision 1.000 Page 20 of 33
Figure 3b: “Set Communication  Ethernet
connection” window
E
THERNET
C
ONNECTION
:
The means of the fields for “Ethernet Connection” are:
In the field “ Device Name (Hostname) ” the Hostname to assign to the
converter is defined;
If the field “ Obtain an IP Address Automatically (DHCP for Cable
Connection) ” is checked, DHCP for LAN connection is enabled;
If the field “ Obtain an IP Address Automatically (DHCP for Wi-Fi
Connection) ” is checked, DHCP for Wi-Fi connection is enabled;
If the field “ Enable DNS ” is checked, DNS protocol is enabled;
In the field “ Primary DNS ” the IP Address of the primary DNS server is
defined;
In the field “ Secondary DNS ” the IP Address of the secondary DNS server
is defined.
L
O
R
A
WAN:
This section is used to define the general parameters of LoRaWAN. The means of
the fields are:
In the field “ RF Band ” the wireless band used for LoRaWAN communication
is defined;
In the field “ Network Type ” the type of LoRaWAN network is defined;
In the field “ Diagnostic Position ” it is possible to define an offset into the
internal memory array where the status of the LoRaWAN end devices
configured is saved. The diagnostic is made bit to bit, so each bit will
represent a status of a single end device:
o
1

End device connected;
o
0  End device not connected.
The bits’ order will be the same of the end devices’ definition inside the LoRaWAN Access section;
In the field “ RX2 Datarate ” the data rate on RX2 window is defined.
Figure 3c: “Set Communication  LoRaWAN” window