ADF Web HD67D17-IP-B2-868MHz, User Manual, Page: 19 / 31

Industrial Electronic Devices
ADFweb.com S.r.l.
User Manual LoRaWAN / BACnet Slave
Document code: MN67D17_ENG Revision 1.000 Page 19 of 31
In the section “BACnet Master” it is possible to select the type of BACnet to use from:
BACnet/IP (it uses Ethernet);
BACnet MS/TP (it uses RS485).
If selected “BACnet/IP” the means of the fields for “BACnet” are:
In the fields “ IP ADDRESS ” the IP address of BACnet/IP side of the converter is defined;
In the fields “ SUBNET Mask ” the SubNet Mask of BACnet/IP side of the converter is
defined;
In the fields “ GATEWAY ” the default gateway of the network is defined. This feature can
be enabled or disabled pressing the Check Box field. This feature is used for going out of
the net;
In the field “ Port ” the port used for BACnet communication is defined. The default port
used for BACnet communication is 47808, but is possible to insert any value;
In the field " BACnet Device Name " the name of BACnet/IP side of the converter is
defined;
In the field “ Device Identifier ” the device instance of BACnet/IP side of the converter is
defined;
If the field “ BACnet description up to 32 chars ” is checked, the description of the
BACnet objects can be up to 32 chars.
If selected “BACnet MS/TP” the means of the fields for “BACnet” are:
In the field “ Baudrate ” the baudrate of BACnet MS/TP side of the converter is defined;
In the field “ Parity ” the parity of BACnet MS/TP side of the converter is defined;
In the field “ BACnet Device Name ” the name of BACnet MS/TP side of the converter is
defined;
In the field “ MAC Address ” the MAC of BACnet MS/TP side of the converter is defined;
The field “ Max Masters ” specifies the highest allowable address for master nodes. The
value shall be less than or equal to 127;
The field “ Max Info Frames ” specifies the maximum number of information frames the
node may send before it must pass the token;
In the field “ Device Istance ” it is possible to assign a number to the BACnet node (used
for the Device Istance);
Figure 3b: “Set Communication” window