Industrial
Electronic Devices
ADFweb.com Srl – IT31010 – Mareno – Treviso INFO:
www.adfweb.com
Phone +39.0438.30.91.31
User Manual
DALI / Modbus Master - Converter
Document code: MN67842_ENG Revision 1.000 Pagina 17 di 43
SET COMMUNICATION:
This section define the fundamental communication parameters of Modbus and DALI bus.
By Pressing the “
Set Communication
” button from the main window for SW67842 (Fig. 2) the window “Set
Communication” appears (Fig. 3).
The means of the fields for the “Modbus Slave” section are:
In the field “
Baudrate
” the baudrate for the serial line is defined;
In the field “
Parity
” the parity of the serial line is defined;
In the field “
ID Device
” the ID of the Modbus side is defined;
In the “
TimeOut (ms)
” the maximum time that the converter attends for the answer from the slave
interrogated is defined;
In the field “
Cyclic Delay (ms)
” the delay between two requests is defined.
The means of the fields for the “DALI” section are:
In the field “
DALI Console Port
” the UDP port used for the communication with ‘DALI Console’
software is defined;
If the field “
Switch off DALI on Timeout
” is checked, the DALI line is switched OFF if there is no
communication with the Modbus slaves for the “
TimeOut (ms)
” defined below.
The means of the fields for the “Ethernet” section are:
In the field “
IP ADDRESS
” the IP address of the converter is defined;
In the field “
SUBNET
Mask
” the SubNet Mask is defined;
In the field “
GATEWAY
” the default gateway of the Ethernet network is defined. This feature can be
enabled or disabled pressing the Check Box field. This feature is used for going out of the net;
Figure 3: “Set
Communication” window
