Industrial
Electronic Devices
ADFweb.com S.r.l.
User Manual
EtherNet/IP Master/ Ethernet
Document code: MN67668_ENG Revision 1.000 Page 16 of 25
Figure 4: “Set EtherNet/IP Slaves Access” window
ETHERNET/IP ACCESS:
By Pressing the “
EtherNet/IP Access
” button from the main window for SW67668 (Fig. 2) the window “Set EtherNet/IP Master Access”
appears (Fig. 4).
This section is used to define the list of the EtherNet/IP Slaves to read/write with the EtherNet.
The means of the fields are:
If the field “
Enable
” is checked, the polling to the EtherNet/IP Slave is enabled;
In the field “
IP Address
” the IP Address of the EtherNet/IP Slave is defined;
In the field “
Start Input
” the starting Input byte of the EtherNet/IP Slave to map on EtherNet side is defined;
In the field “
Num Input
” the number of consecutive Input byte to map on EtherNet side is defined;
In the field “
Start Output
” the starting Output byte of the EtherNet/IP Slave to write from EtherNet side is defined;
In the field “
Num Output
” the number of consecutive Output byte to write from EtherNet side is defined;
In the field “
Time Poll
” the polling time in ms is defined;
In the field “
Instance T > O
” the instance of the assembly for the Target to Originator data direction is defined;
In the field “
Conn. Point T > O
” the connection point of the assembly for the Target to Originator data direction is defined;
In the field “
Instance O > T
” the instance of the assembly for the Originator to Target data direction is defined;
In the field “
Conn. Point O > T
” the connection point of the assembly for the Originator to Target data direction is defined;
